Photo Layout 4 × 6.75 in sheet
1 of 1

Paper & printing

Defaults match Liene 4 × 6.75 in paper. Only change these if a printed frame doesn’t measure what it should.

Paper size
Magnet size (inches)
Gap between frames (inches)
Size correction 100%

Frame not printing at the right size?

  1. Turn on Print frame outline below and print one test sheet.
  2. Measure the printed frame with a ruler.
  3. Set correction to target ÷ measured × 100. A 2″ frame printing at 1.9″ → 105%.
  4. Re-print to confirm, then turn the outline off.
Gravity while you position
Snap to frame edgesPulls the photo flush with an edge when it comes close, so you don’t leave a white sliver.
Snap to centrePulls the photo to dead centre, horizontally and vertically.
Keep photos uprightStraightens a nearly-square rotation to exactly upright or a quarter turn.
Printing
Crop photo to frameOff lets the photo spill past the frame onto the white sheet. Always on for multi-frame layouts.
Print cut marksFaint corner ticks showing where to cut or place the magnet.
Print frame outlinePrints the frame edge itself. For calibration test sheets.
Fade outside framePreview only — dims what falls outside. Never printed.
Export quality

Projects

Save a half-finished sheet and pick it back up later — photos and all.

Save this sheet

Saved

    Nothing saved yet.

    Finished sheet
    Download the file instead

    Custom size

    How big is one photo? The sheet is filled with as many as will fit.

    ×

    Snapping

    Turn off any pull that’s getting in your way. Takes effect straight away.

    Snap to frame edgesPulls the photo flush with an edge.
    Snap to centrePulls the photo to dead centre.
    Keep photos uprightStraightens a nearly-square rotation.

    Start over?

    This clears every photo on the sheet. You can undo it straight after.